CH4x4 Rocker Switch Dodge Ram Bumper Light Symbol is a single throw ON – OFF switch designed to operate your 12 volt accessories. They have a face surface size of 2” (50mm) x 1” (25mm) and uses a standard din size mounting hole of 1.41” (36mm) x .86” (22mm) this is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.
All symbols are laser etched directly onto the switch face to ensure long image life. We do not use stickers or ink which will wear off in a very short time.
• Single Pole Single Throw ON-OFF switch
• Black hard surface rocker
• Two LEDs in the switch
• Upper LED is ON only when the switch is turned ON
• Lower LED is independent
• Both LEDs have separate grounds
• Same size as the Carling and ARB switches
• Rated 20A 12V
• No rear barriers between terminals
• Wiring diagram supplied with switch
CH4x4 Rocker Switch Dodge Ram Bumper Light Symbol is a product of Cruiserheads Store
NOTE: These switches are not intended or manufactured to replace original manufacturer equipment or switches that came in your vehicle from factory, in many cases you will have to trim/cut or adapt the mounting hole for the switch to fit, we have many adapters or switch panels and pods that will help you install them in your vehicles depending on the application. Please make sure you verify if your vehicle is compatible with adding additional switches since there are many vehicles out in the industry with different set ups. Also check with a Mobile audio and electronics professional to make sure you are getting the correct installation for your vehicle. (CONTACT US IF NOT SURE IF IT FITS YOUR VEHICLE BEFORE YOU BUY)
Dodge Ram is a registered trademark of FCA US LLC. CH4x4 Industries (Cruiserheads, LLC) is an independent manufacturer of replacement parts for Dodge® vehicles and is not affiliated with FCA US LLC. Part numbers and trade marks used herein are for reference purposes only.